Nummer: 58498
Code:
smartctl 5.41 2011-06-09 r3365 [x86_64-linux-2.6.38.2-grsec-xxxx-grs-ipv6-64] (local build)
Copyright (C) 2002-11 by Bruce Allen, http://smartmontools.sourceforge.net
=== START OF INFORMATION SECTION ===
Model Family: Seagate Barracuda 7200.12
Device Model: ST3750528AS
Serial Number: 9VP9RK5J
LU WWN Device Id: 5 000c50 02cdcb473
Firmware Version: CC44
User Capacity: 750.156.374.016 bytes [750 GB]
Sector Size: 512 bytes logical/physical
Device is: In smartctl database [for details use: -P show]
ATA Version is: 8
ATA Standard is: ATA-8-ACS revision 4
Local Time is: Wed Feb 26 15:12:29 2014 CET
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
General SMART Values:
Offline data collection status: (0x82) Offline data collection activity
was completed without error.
Auto Offline Data Collection: Enabled.
Self-test execution status: ( 121) The previous self-test completed having
the read element of the test failed.
Total time to complete Offline
data collection: ( 609) seconds.
Offline data collection
capabilities: (0x7b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 1) minutes.
Extended self-test routine
recommended polling time: ( 150) minutes.
Conveyance self-test routine
recommended polling time: ( 2) minutes.
SCT capabilities: (0x103f) SCT Status supported.
SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.
SMART Attributes Data Structure revision number: 10
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000f 102 099 006 Pre-fail Always - 50852233
3 Spin_Up_Time 0x0003 095 095 000 Pre-fail Always - 0
4 Start_Stop_Count 0x0032 100 100 020 Old_age Always - 19
5 Reallocated_Sector_Ct 0x0033 094 094 036 Pre-fail Always - 275
7 Seek_Error_Rate 0x000f 086 060 030 Pre-fail Always - 404394225
9 Power_On_Hours 0x0032 069 069 000 Old_age Always - 27769
10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 100 100 020 Old_age Always - 19
183 Runtime_Bad_Block 0x0000 100 100 000 Old_age Offline - 0
184 End-to-End_Error 0x0032 100 100 099 Old_age Always - 0
187 Reported_Uncorrect 0x0032 088 088 000 Old_age Always - 12
188 Command_Timeout 0x0032 100 098 000 Old_age Always - 13
189 High_Fly_Writes 0x003a 100 100 000 Old_age Always - 0
190 Airflow_Temperature_Cel 0x0022 071 056 045 Old_age Always - 29 (Min/Max 18/44)
194 Temperature_Celsius 0x0022 029 044 000 Old_age Always - 29 (0 14 0 0)
195 Hardware_ECC_Recovered 0x001a 031 022 000 Old_age Always - 50852233
197 Current_Pending_Sector 0x0012 100 100 000 Old_age Always - 4
198 Offline_Uncorrectable 0x0010 100 100 000 Old_age Offline - 4
199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age Always - 0
240 Head_Flying_Hours 0x0000 100 253 000 Old_age Offline - 37233071516845
241 Total_LBAs_Written 0x0000 100 253 000 Old_age Offline - 654295942
242 Total_LBAs_Read 0x0000 100 253 000 Old_age Offline - 437404142
SMART Error Log Version: 1
ATA Error Count: 12 (device log contains only the most recent five errors)
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.
Error 12 occurred at disk power-on lifetime: 27757 hours (1156 days + 13 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 79 30 80 00 Error: UNC at LBA = 0x00803079 = 8401017
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 08 78 30 80 e0 00 26d+11:30:22.998 READ DMA
27 00 00 00 00 00 e0 00 26d+11:30:22.972 READ NATIVE MAX ADDRESS EXT
ec 00 00 00 00 00 a0 00 26d+11:30:22.964 IDENTIFY DEVICE
ef 03 46 00 00 00 a0 00 26d+11:30:22.943 SET FEATURES [Set transfer mode]
27 00 00 00 00 00 e0 00 26d+11:30:22.896 READ NATIVE MAX ADDRESS EXT
Error 11 occurred at disk power-on lifetime: 27757 hours (1156 days + 13 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 79 30 80 00 Error: UNC at LBA = 0x00803079 = 8401017
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 08 78 30 80 e0 00 26d+11:30:20.118 READ DMA
27 00 00 00 00 00 e0 00 26d+11:30:20.091 READ NATIVE MAX ADDRESS EXT
ec 00 00 00 00 00 a0 00 26d+11:30:20.083 IDENTIFY DEVICE
ef 03 46 00 00 00 a0 00 26d+11:30:20.062 SET FEATURES [Set transfer mode]
27 00 00 00 00 00 e0 00 26d+11:30:20.015 READ NATIVE MAX ADDRESS EXT
Error 10 occurred at disk power-on lifetime: 27757 hours (1156 days + 13 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 79 30 80 00 Error: UNC at LBA = 0x00803079 = 8401017
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 08 78 30 80 e0 00 26d+11:30:17.206 READ DMA
27 00 00 00 00 00 e0 00 26d+11:30:17.179 READ NATIVE MAX ADDRESS EXT
ec 00 00 00 00 00 a0 00 26d+11:30:17.171 IDENTIFY DEVICE
ef 03 46 00 00 00 a0 00 26d+11:30:17.148 SET FEATURES [Set transfer mode]
27 00 00 00 00 00 e0 00 26d+11:30:17.103 READ NATIVE MAX ADDRESS EXT
Error 9 occurred at disk power-on lifetime: 27757 hours (1156 days + 13 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 79 30 80 00 Error: UNC at LBA = 0x00803079 = 8401017
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 08 78 30 80 e0 00 26d+11:30:14.333 READ DMA
27 00 00 00 00 00 e0 00 26d+11:30:14.307 READ NATIVE MAX ADDRESS EXT
ec 00 00 00 00 00 a0 00 26d+11:30:14.274 IDENTIFY DEVICE
ef 03 46 00 00 00 a0 00 26d+11:30:14.251 SET FEATURES [Set transfer mode]
27 00 00 00 00 00 e0 00 26d+11:30:14.199 READ NATIVE MAX ADDRESS EXT
Error 8 occurred at disk power-on lifetime: 27757 hours (1156 days + 13 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 79 30 80 00 Error: UNC at LBA = 0x00803079 = 8401017
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 08 78 30 80 e0 00 26d+11:30:11.385 READ DMA
27 00 00 00 00 00 e0 00 26d+11:30:11.358 READ NATIVE MAX ADDRESS EXT
ec 00 00 00 00 00 a0 00 26d+11:30:11.310 IDENTIFY DEVICE
ef 03 46 00 00 00 a0 00 26d+11:30:11.287 SET FEATURES [Set transfer mode]
27 00 00 00 00 00 e0 00 26d+11:30:11.234 READ NATIVE MAX ADDRESS EXT
SMART Self-test log structure revision number 1
Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
# 1 Extended offline Completed: read failure 90% 27764 14139643
# 2 Short offline Completed without error 00% 10419 -
# 3 Short offline Completed without error 00% 10413 -
# 4 Short offline Completed without error 00% 10413 -
# 5 Short offline Completed without error 00% 8547 -
# 6 Short offline Completed without error 00% 8541 -
# 7 Short offline Completed without error 00% 8541 -
# 8 Short offline Completed without error 00% 8495 -
# 9 Extended offline Aborted by host 90% 0 -
#10 Short offline Completed without error 00% 0 -
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.
