bene
27.10.13, 19:49
Vermutlich nicht, normal wird es eigentlich innerhalb weniger Stunden bearbeitet sofern das Ticket entsprechend freigegeben ist....
=== START OF INFORMATION SECTION === Device Model: TOSHIBA DT01ACA050 Serial Number: X281K20FS Firmware Version: MS1OA750 User Capacity: 500.107.862.016 bytes Device is: Not in smartctl database [for details use: -P showall] ATA Version is: 8 ATA Standard is: ATA-8-ACS revision 4 Local Time is: Thu Oct 17 14:52:46 2013 CEST SMART support is: Available - device has SMART capability. SMART support is: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x84) Offline data collection activity was suspended by an interrupting command from host. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: (4934) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 1) minutes. Extended self-test routine recommended polling time: ( 83) minutes. SCT capabilities: (0x003d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE 1 Raw_Read_Error_Rate 0x000b 100 100 016 Pre-fail Always - 0 2 Throughput_Performance 0x0005 136 136 054 Pre-fail Offline - 90 3 Spin_Up_Time 0x0007 100 100 024 Pre-fail Always - 224 4 Start_Stop_Count 0x0012 100 100 000 Old_age Always - 8 5 Reallocated_Sector_Ct 0x0033 050 050 005 Pre-fail Always - 1011 7 Seek_Error_Rate 0x000b 100 100 067 Pre-fail Always - 0 8 Seek_Time_Performance 0x0005 108 108 020 Pre-fail Offline - 37 9 Power_On_Hours 0x0012 099 099 000 Old_age Always - 7627 10 Spin_Retry_Count 0x0013 100 100 060 Pre-fail Always - 0 12 Power_Cycle_Count 0x0032 100 100 000 Old_age Always - 8 192 Power-Off_Retract_Count 0x0032 096 096 000 Old_age Always - 5141 193 Load_Cycle_Count 0x0012 096 096 000 Old_age Always - 5141 194 Temperature_Celsius 0x0002 222 222 000 Old_age Always - 27 (Lifetime Min/Max 12/39) 196 Reallocated_Event_Count 0x0032 036 036 000 Old_age Always - 1327 197 Current_Pending_Sector 0x0022 100 100 000 Old_age Always - 0 198 Offline_Uncorrectable 0x0008 100 100 000 Old_age Offline - 0 199 UDMA_CRC_Error_Count 0x000a 200 200 000 Old_age Always - 0 SMART Error Log Version: 1 No Errors Logged SMART Self-test log structure revision number 1 Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Short offline Completed without error 00% 789 - # 2 Short offline Completed without error 00% 784 - # 3 Short offline Completed without error 00% 784 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay.